SERVICE MANUAL
ADVANCE OVENS
04/02/2020 116
17.2. ON/OFF
The oven is switched on/off with the main ON/OFF switch. Each time that the oven is
switched on, the last-used values are displayed. If this is the first time the oven is
switched on, the defect values are displayed.
When the oven is switched on, it adopts the last used parameters. If the function is
changed, the values of the function being used are stored and are reloaded if you return
to this function.
17.3. SELECTION OF COOKING MODES
On selecting the required mode, the relevant icon is highlighted with respect to the others.
The available cooking modes are:
- Convection - Mixed -
Regeneration - Steam
When the appliance is switched on, it adopts the last used parameters.
If the function is changed, the values of the function being used are stored and are reloaded if you return to this
function.
17.4. HUMIDITY SELECTION
This section shows the humidity level selected for the oven. Blue represents moist air, red dry air, while when the
icon is off or black (only in Convection mode), the required humidity level is displayed. These are the default ranges
and values of each operating mode:
• Convection: Range (0÷100 ºC) 0% default setting
• Mixed: Range (0÷100 ºC) 50% default setting
• Regeneration: Range (80 ºC) 80% default setting
• Steam: Range (100 ºC) 100 % default setting
To change the moisture level, press
and The increase/decrease is in steps of 10%.
The buttons are only enabled in the Convection or Mixed mode, as the humidity value is fixed in the other two
operating modes.
To Next Page
Loading...
