SERVICE MANUAL
ADVANCE OVENS
04/02/2020 79
15.15. RESET GAS (until 01/01/2016)
When the ignition control has tried unsuccessfully to complete the ignition operation 3 times, the appliance is
blocked and the burner blocked signal is emitted. The Burner Blocked LED lights up until the user presses the Reset
gas button. This will restart a new sequence of three ignition attempts.
15.16. RESET GAS (after 01/01/2016)
When the ignition control has tried unsuccessfully to complete the ignition operation 3 times, the appliance is
blocked and the burner blocked signal is emitted. The appliance will display ERROR-14 until the user switches the
appliance off and on by pressing ON/OFF, and a new sequence of three ignition attempts will be run.
15.17. WASH (from 01/01/2016)
The “Wash” function is activated by pressing Wash. The appliance must be in ON and Stop mode,
the door of the chamber closed and the temperature of the chamber below 65 ºC. If the chamber
temperature is more than 65 ºC, the message HIGH TEMP is displayed and the appliance requests
that the door is opened to start a COOL DOWN cycle.
The cleaning programme starts with a dirt softening phase in Steam mode (to skip this phase, press Wash again),
displaying the message WASHING. This process lasts 10 minutes. Next the oven displays the message
ADD SOAP so that the user sprays detergent inside the chamber. After the detergent has been applied
and the chamber door closed, the message PUSH START is displayed and the appliance continues with
the cleaning process. Once the wash process has resumed, the appliance waits 4 minutes, displaying
the message WASHING. After 4 minutes, the appliance moves on to the rinse phase during which it is in Steam
mode, and the wash solenoid valve is activated for 5 seconds ON and 5 seconds OFF, and the message RINSING is
displayed. The duration time of this phase depends on the size of the oven as follows:
- Model 061
– 8 minutes
- Model 101
– 8 minutes
- Model 102
– 10 minutes
- Model 201
– 15 minutes
- Model 202
– 20 minutes
On completion of the wash, the oven displays the message End.
To leave the wash programme, switch off the oven, pressing the OFF button or the Wash button. Otherwise, after
one minute the oven will exit the wash mode automatically.
To abort the wash programme press the Star/Stop button and if the detergent spray phase has been reached, the
oven will run a rinse cycle.
It is possible to abort the ongoing wash programme by pressing the START/STOP button at any point in the cycle.
If it is pressed before adding the soap, the wash cycle will end automatically. If the soap has already been added,
the rinse cycle will be run and the following messages displayed:
“WASH STOP”, “RINSE”, “PUSH START”
When the START/STOP button is pressed, the wash programme resumes from the Rinse cycle.
If the oven has been switched off after the spraying of detergent, or there has been a power cut, the same
procedure will apply and the rinse cycle will be resumed when the oven is switched on again.
There is a secret sequence for aborting the rinse cycle: VHM button pressed for 5 seconds.
Before using the oven to cook, make sure there are no traces of detergent or degreasing products inside the
cooking chamber. Remove possible traces of chemicals and rinse the inside of the cooking chamber thoroughly
with the hand shower.
Fagor Industrial recommends the use of the product KOIPERRE PLUS for this process. Other chemical processes
may damage the appliance or its components.
To Next Page
Loading...
