SERVICE MANUAL
ADVANCE OVENS
04/02/2020 89
Reset Option to reset all log parameters.
DSI = [HIS], DSD = [RST], DID = [INI]
EXHIBITION
Option allowing the oven to be set in Exhibition mode. To enter, press Humidifier.
DSI = [OPT]
DSD = [OP8]
DII = [SHO]
DID = [INI]
To exit this mode, return to the SETTINGS menu (Cool Down and Humidify together every 5 seconds), go to option
24 OUT and confirm by pressing Humidify.
When the oven is operating in Exhibition mode, only the Interface and the RG and LZ, outputs should operate, all
other inputs/outputs are disabled and all errors are ignored. The values of the TC and TN probes are fixed.
To indicate that the oven is in exhibition mode, the last dot of the remaining time remains fixed. The behaviour of
the interface is as in true mode.
SERIAL NO
Option allowing the serial number of the over to be entered or displayed. An alphanumeric sequence of up to 10
characters may be used.
DSI = [OPT]
DSD = [OP9]
DII = [ SN]
DID = [INI]
To display, press Humidifier, press again to return to the main menu. The ten alphanumeric characters are
distributed as follows:
DSI = [C1C2C3]
DSD = [C4C5C6]
DII = [C7C8C9]
DID = [C10]
To change the value already entered, hold down the Humidifier button for 5 seconds until the first character starts
to flash. It is now possible to change the 10 pre-established characters. To change the character in question, use
the time selector. Press the Humidifier button to confirm and move to the next character. To go to the previous
character, press Cool Down. If you are at the first character this will take you to the main menu.
TEST No
Option enabling oven test number to be entered or displayed A 3-digit sequence can be entered.
DSI = [OPT]
DSD = [O10]
DII = [ CN]
DID = [XXX]
SOFTWARE VERSION
This displays the software version included with the oven. The version uses 12 numbers, PPCCVVGGG
’G’, with the
following meaning:
- PP Software version of the control holder card.
- CC Software version of the chamber card.
- VV Software version of the steam or boiler card. This card is not supplied with the CONCEPT range and
therefore no value is displayed
- GG: Software version of the gas card. For electric ovens, no value is displayed
DSI = [OPT]
DSD = [O11]
DII = [VER]
DID = [INI]
To Next Page
Loading...
