Fagor APG-061 - 16.24. TYPES OF FAULT

SERVICE MANUAL
ADVANCE OVENS
04/02/2020 111
16.24. TYPES OF FAULT
ERROR DESCRIPTION CONSEQUENCE
E1 SENSOR TC
Camera probe broken. TC
out of range [-5 ÷ 330 ºC].
The oven is completely disabled.
E2 SENSOR TN
Core probe TN damaged.
TN out of range [-10 ÷ 330
ºC].
The spike and delta function is disabled.
E3 SENSOR TV
Steam outlet temperature
probe (TV) faulty. TV out
of range [-5 ÷ 330 ºC].
It is only possible to operate in
Convection mode, omitting water
condensation.
E4 SENSOR TG
Steam generator
temperature probe TG
faulty. TG out of range [-5 -
330 ºC].
It is only possible to operate in
Convection mode.
E5 WATER LEVEL
Detects water level at
maximum, but not at
minimum for 3 seconds.
It is only possible to operate in
Convection mode.
E6 CALIBRATION
It was not possible to
calibrate in 15 minutes.
The machine continues to function
normally.
E7 AE ERROR
- AE inlet does not work.
- The connection has
been cut off.
- The motor does not
start within 10 seconds
of a start request.
- Does not exceed 500
rpm within 20 seconds
of a start request.
The machine is completely disabled.
E8 WATER REQUIRED
VDV has been running for
7 or more minutes and the
maximum level has not
been reached.
It is only possible to operate in
Convection mode.
E9 DRAIN ERROR
VAC has been running for
1 or more minutes and
level does not fall below
minimum.
E10 CV FAULT
With TG < 80 ºC, when CV
operates, and in 10
minutes TG does not rise
more than 3 ºC.
It is only possible to operate in
Convection mode.
E11 CC FAULT
The CC operates for 25
minutes and TC does not
rise 3 or more degrees.
Tc<(
Temperature Setting -
10ºC)
The oven is completely disabled.
E12 CONTROL TEMP
The NTC of controller
reaches 60 ºC, but does
not exceed 70 ºC.
The oven operates normally and the bell
is not heard. This message should be
displayed every 3 minutes for 30
seconds.
E13 BLOWER Q1 (only AG) Chamber blower error. The oven is completely disabled.