SERVICE MANUAL
ADVANCE OVENS
04/02/2020 120
If the operation is cancelled, the oven switched off, there is a power failure or the appliance is
disconnected, the next time it is switched on, the machine indicates that the wash was interrupted, and a rinse
cycle is run to remove any soap that may be left in the chamber.
Press START/STOP to begin or end the cleaning process.
For each of the wash programmes, follow the instructions shown on the screen.
The Cool Down programme should be completed before starting a wash.
CLEANING PROCESS
1. LZ and Ms/Mb operate. The display must indicate the chamber temperature and the time left to complete
the selected programme.
2. The fluepipe behaves as follows:
• Electric oven: Fluepipe open
• Gas oven: Fluepipe closed (otherwise water will leak out )
3. VAC operates for 3 seconds, the level of the boiler should drop below the minimum level. If the low level is
not reached, after 5
” re-operate the VAC for a further 3” and continue so. If after 1 minute the minimum level
is not reached, the corresponding error is displayed. (See table of errors).
4. Operate VDV until maximum level is reached. If this is not reached within 7 minutes, the corresponding error
should be displayed.
5. Now continue with the specifications for each wash programme.
6. Lastly, everything is switched off, all the outputs are set to zero and the display shows the message END OF
WASH.
If the door is opened during a wash cycle, the programme stops, and restarts when the door is closed.
There is an option on the screen to cancel the current wash programme, the operation is aborted when
START/STOP is pressed, and proceeds as follows if the drying phase has not been reached (if it has, the wash
cycle is considered to have ended).
• The message WASH INTERRUPTED is displayed on the screen.
• When the user confirms this message, the cycle proceeds to the rinse stage, displaying the message
RINSING on the screen.
• Mc activated for 30” (drainage closes)
• The rinse cycle is run
Similarly, if the controller was switched off during the wash cycle without reaching the drying cycle, the above
sequence is followed when the oven is switched back on.
If the oven is switched off during the rinse phase, the programme will restart at the point at which it was interrupted
when the oven is switched back on.
There is an option to abort the rinse cycle. Press the ON button and then press the START/STOP button for 5
seconds.
QUICK RINSE
The TFT displays the name of the wash programme
061 and 101
1/3 (075 ml.)
102
½ (112 ml.)
201 and 202
2/3 (150 ml.)
1 – Rapid rinse
2
– Gentle wash
3
– Medium wash
4
– Intense wash
To Next Page
Loading...
