Fagor APG-061 - 15.7. TIME SELECTION; 15.8. HEATING POWER AND FAN SPEED

SERVICE MANUAL
ADVANCE OVENS
04/02/2020 75
15.7. TIME SELECTION
The encoder is used to increase /decrease the cooking time setting. This enables the increase/decrease of the
cooking time setting in units.
o Remaining time: Displays the cooking time remaining. This time decreases every minute, displaying the final point
if the countdown is active.
When the time reaches 0, the number flashes and the buzzer is heard until the START/STOP button is pressed, the
door is opened or after 30 seconds. If the door is not opened, or if the START/STOP, button is not pressed, the
acoustic/visual warning is repeated for 30 seconds every 3 minutes. When the door is opened or the
START/STOP, button is pressed, the remaining time is automatically re-established, loading the stipulated
times.
o Time setting: Time setting selected by the user. The maximum possible time is 300 minutes. When the operating
mode is changed, the last-used value in this mode is automatically loaded. If it is turned quickly (more than half
a turn per second), the increase/decrease is in steps of 10. If the encoder is turned more quickly, the time is
infinite, both time markers indicating
“---".
If the oven is on and the setting is increased/decreased, the remaining time will vary in proportion to the
increase/decrease made.
15.8. HEATING POWER AND FAN SPEED
The heating powers that can be selected are Maximum Power and Medium Power. In electric ovens, this is
performed by acting on the two chamber heating contactors (Maximum power) or by acting on only one of these
(Medium Power). In the case of the ACE-061 ovens, this function is performed by the activation time of the only
chamber heating contactor (30 seconds ON and 10 seconds OFF).
1. "Fan Power / Speed" selector button
2. "Maximum power/Maximum speed of fan" display
3. "Medium power/Maximum speed of fan" display
4. "Medium power/Medium speed of fan" display
In addition, the chamber fan speeds that can be selected are Maximum Speed and Medium Speed.
The options we can select for Heating Power and Fan Speed are:
- Maximum power / maximum speed
- Medium power / Maximum speed
- Medium power / Medium speed
Remaining time
Time setting
Encoder
1
2
4
3