SERVICE MANUAL
ADVANCE OVENS
04/02/2020 56
13. INSTALLATION OF THE MACHINE
THE MANUFACTURER MAY NOT BE HELD LIABLE FOR ANY PROPERTY DAMAGE
OR PERSONAL INJURY RESULTING FROM THE INCORRECT INSTALLATION, USE,
MAINTENANCE OR REPAIR, OR CAUSED BY
FAILURE TO COMPLY WITH THE
STANDARDS AND INSTRUCTIONS PROVIDED.
13.1. LOCATION
It is necessary to install an extraction hood for the optimum operation of the appliance.
Place the equipment in a sufficiently ventilated room, in accordance with the current regulations, to prevent the
formation of unacceptable concentrations of harmful substances in the installation site.
The equipment should be installed in accordance with its dimensions. Appliances must only be installed on and/or
against fireproof surfaces.
Inspect final location of the equipment prior to installation to prevent damage during use.
Unless otherwise indicated, the parts that have been protected by the manufacturer must not be manipulated by
the installer.
• The placement, installation, repairs and/or modifications must always be carried out by an
Authorised Service Technician in accordance with the manufacturer's instructions and the
applicable regulations.
• Do not change the position of or handle the machine components, as this may affect the
operating safety.
• The appliance must be correctly levelled and the electrical cables, gas pipes, water and
drainage hoses must not be trapped or contain kinks.
• The appliance has been designed to operate at ambient temperatures ranging from 5 ⁰C to
40 ⁰C and must not be used at temperatures below 5 ºC.
• The appliance or any of its parts must never be used as a support and objects must not be placed
on top.
• Do not install the appliance in places exposed to jets of water.
• This appliance must be installed in accordance with the current applicable legislation. It may only
be installed on premises which are correctly ventilated in order to prevent the formation of
unacceptable concentrations of substances harmful to human health.
• You must check that there are no gas leaks. NEVER use a flame to check for leaks.
• The gases leaving the fluepipe are at high temperatures and may cause burns. Do NOT obstruct
the fluepipe output.
• The parts which are protected must not be handled.
If there is a smell of gas:
• Immediately close the gas mains tap.
• Try to ventilate the premises.
• Avoid the formation of sparks or flames.
•
Leave the room and contact your gas supplier.
To Next Page
Loading...
