Fagor AXD 1.08 - Page 116

Drive modules
188
3.
DRIVE MODULES
Modular drives
116
DDS
HARDWARE
Ref.1310
AXD/SPD 2.50/2.75, SPD 2.85
These drive modules have the following connectors:
F. H3/50
Connectors of “AXD/SPD 2.50/2.75, SPD 2.85” modular drives.
1. Power connector for motor connection.
2. Power bus that feeds the drive modules from the power supply through metal plates.
X1. Connector that may be used to establish communication between modules through the internal bus.
X2. Connector for the basic control signals.
X3. Connector with two possible uses:
• as output of the encoder simulator.
• as input of the direct feedback for the position loop.
X4. Connector for motor feedback connection (encoder).
X5. Connector for RS-232 serial line connection.
X6. SERCOS or CAN interface connector.
X7. Connector for external acknowledgment of the status of the safety relay.
SL1.Slot for the cards A1, 16DI-8DO and 8DI-16DO.
SL2.Slot for the cards 16DI-8DO and 8DI-16DO.
X4
X3
STATUS
DISPLAY
X5
X6
SL2
SL1
X1
DRIVE MODULE
DANGER
HIGH VOLTAGE
DISCHARGE TIME > 4 Min
UVW
+24 Vdc
0 V
DR.
O.K.
SPEED
ENABLE
DRIVE
ENABLE
GND
AS1
AS2
X7
X2
UVW
2
1
X1
Warning. AC touch current greater
than 3.5 mA. Install a ground wire with
a section of at least 10 mm² Cu or 16
mm² Al.
X5
X3
X4
BOOT button. Software update and
SERCOS/CAN.Transmission speed
selection.
AS1
AS2
GND
DRIVE
ENABLE
SPEED
ENABLE
DR.
O.K.
0V
+24Vdc
X7
X2
RESET button
X6X6
SL1
SL2