Installation manual
CNC 8035
MACHINE PARAMETERS
Axis parameters
4.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·121·
NPOINTS (P16)
Indicates the number of leadscrew error compensation points available in the table. The values in
this table will be applied if a.m.p. "LSCRWCOM" (P15) is ON.
DWELL (P17)
Indicates the dwell from the moment the "ENABLE" signal is activated until the velocity command
is sent out.
ACCTIME (P18)
Defines the acceleration stage or the time it takes the axis to reach the feedrate selected with a.m.p.
GOFFED (P38). This time is also valid for the deceleration stage.
INPOSW (P19)
Indicates the width of the IN POSITION zone (dead band) where the CNC considers the axis to be
in position.
INPOTIME (P20)
Indicates the time period that the axis must remain in the "IN POSITION" zone in order to consider
it to be in position.
On axes that are only controlled during the interpolation or the positioning (dead axes), this prevents
the CNC from considering the block completed before the axis has stopped and could get out of
the in-position zone.
MAXFLWE1 (P21)
Indicates the maximum following error allowed when this axis moves.
Possible values
Integer numbers between 0 and 255.
Default value: 30
Possible values
Integers between 0 and 65535 ms.
Default value: 0 (none)
Possible values
Integers between 0 and 65535 ms.
Default value: 0 (none)
Possible values
Between 0 and 99999.9999 degrees or millimeters.
Between 0 and 3937.00787 inches.
Default value: 0.01 mm.
Possible values
Integers between 0 and 65535 ms.
Default value: 0
Possible values
Between 0 and 99999.9999 degrees or millimeters.
Between 0 and 3937.00787 inches.
Default value: 30 mm.
To Next Page
Loading...
