Installation manual
CNC 8035
4.
MACHINE PARAMETERS
Tables
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·176·
Considerations and limitations
When defining the profile points in the table, the following requirements must be met:
• The axis points must be in sequential order starting from the most negative (least positive) point
to be compensated.
• For those points outside the compensation zone, the CNC will apply the compensation value
corresponding to the table point closest to them.
• The amount of error of the machine reference point may have any value.
• The error difference between two consecutive points must not be greater than the distance
between them (maximum slope= 100%).
Bidirectional compensation of the leadscrew error is available from versions V7.11
(mill) and V8.11 (lathe) on.
When updated from a version that does not have bidirectional compensation, it keeps
the error values in the positive direction and it sets a zero error in the negative direction
for all the points.
When changing to a version that does not have bidirectional compensation, it keeps
the error values in the positive direction, but it loses the error values in the negative
direction. Also, the amount of error for the machine reference point must be zero.
To Next Page
Loading...
