Installation manual
CNC 8035
5.
CONCEPTS
Axes and coordinate systems
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·180·
The figure below shows an example of the nomenclature of the axes on a milling-profiling machine
with a tilted table.
Axis selection
Out of the 9 possible axes that there could be, the CNC lets the OEM select up to 3 of them at the
mill model and 2 of them at the lathe model.
Moreover, all the axes should be suitably defined as linear, rotary, etc. through the axis machine
parameters.
There is no limitation to the programming of the axes, and up to 3 axes may be interpolated at the
same time.
Example of milling.
The machine has two regular linear axes: X, Y and Z, an analog spindle (S) and a handwheel.
Setting of g.m.p. AXIS1 (P0) through AXIS8 (P7).
The CNC activates a machine parameter table for each axis (X, Y, Z, U) and another one for the
spindle (S).
a.m.p. AXISTYPE (P0) must be set as follows.
s.m.p. SPDLTYPE (P0) must be set as follows:
Likewise, a.m.p DFORMAT (P1) and s.m.p. DOFORMAT (P1) must be properly set to indicate their
display formats.
AXIS1 (P0) = 1 X axis associated with feedback X1 and output O1.
AXIS2 (P1) = 2 Y axis associated with feedback X2 and output O2.
AXIS3 (P2) = 3 Z axis associated with feedback X3 and output O3.
AXIS4(P3)=10 Spindle (S) associated with feedback X5 (1-6) and output O5.
AXIS5 (P4) = 0
AXIS6 (P5) = 0
AXIS7 (P6) = 11 Handwheel associated with feedback input X6 (1-6).
AXIS8 (P7) = 0
X axis AXISTYPE (P0) = 0 Regular linear axis
Y axis AXISTYPE (P0) = 0 Regular linear axis
Z axis AXISTYPE (P0) = 0 Regular linear axis
Spindle SPDLTYPE (P0) = 0 ±10V spindle analog output.
To Next Page
Loading...
