Installation manual
CNC 8035
LOGIC CNC INPUTS AND OUTPUTS
General logic outputs
10.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·357·
ADVINPOS (M5537)
It is used on punch presses that have an eccentric cam as a punching system.
The CNC sets this signal high a specific time period before the axes reach position. This time is set
by g.m.p. ANTIME (P69).
This reduces idle time, thus increasing the number of punches per minute.
INTEREND (M5538) | INPOS (M5539)
The CNC uses these two signals to let the PLC "know" that the theoretical interpolation between
axes has been completed (INTEREND) and that all the axes involved in the interpolation are in
position (INPOS).
The CNC sets the "INTEREND" signal high when the interpolation is ended being low while in
execution.
When the CNC verifies that all the axes have been within the dead band (in position zone INPOSW
P19) for a time period indicated in the a.m.p INPOTIME (P20), it will consider that all of them are
in position and it will inform the PLC by setting the logic output "INPOS" high.
The logic output "INTEREND" can be used when it is required to activate mechanisms before the
axes reach their position.
DM00 (M5547)
The CNC sets this signal high to tell the PLC that the auxiliary function M00 (program stop) is
programmed in the block being executed.
DM01 (M5546)
The CNC sets this signal high to tell the PLC that the auxiliary function M01 (conditional stop) is
programmed in the block being executed.
DM02 (M5545)
The CNC sets this signal high to tell the PLC that the auxiliary function M02 (program end) is
programmed in the block being executed.
DM03 (M5544)
The CNC sets this signal high to tell the PLC that the spindle is turning clockwise or that the auxiliary
function M03 is programmed in the block being executed.
DM04 (M5543)
The CNC sets this signal high to tell the PLC that the spindle is turning counter-clockwise or that
the auxiliary function M04 is programmed in the block being executed.
DM05 (M5542)
The CNC sets this signal high to tell the PLC that the spindle is stopped or that the auxiliary function
M05 is programmed in the block being executed.
To Next Page
Loading...
