Installation manual
CNC 8035
1.
CNC CONFIGURATION
CNC structure
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·52·
Slot "CMPCT FLASH
Compartment of the Key Compact Flash (KeyCF card for CNC configuration)
The CMPCT FLASH slot is located on the left side of the CNC.
This slot is used for the KeyCF that may be used to update the software versions among other
operations.
The KeyCF supplied by Fagor with each CNC has an identification code corresponding to:
• The card id (all the cards are different).
• The software features that have been purchased for that unit
The id code only needs very little memory space. The rest of memory space of the KeyCF may be
used to store data on machine customizing (user screens, PLC program backup and/or machine
parameters, etc.) as well as user part-programs.
The KeyCF cannot be accessed manually from the outside, but it can via DNC. The CNC will
recognize it as <Hard Disk>. This may be observed by accessing the left panel of the <explorer>.
Slot "CMPCT FLASH"
KeyCF card for CNC configuration
To Next Page
Loading...
