Self-teaching manual
36
·TC· Option
MANUAL PRACTICE.
3
3.2 Home search.
After powering the machine up, it is recommended to home the axes just in case they have been moved while the machine
was turned off. There are two ways to do a home search.
Manual home search.
Each axis is homed separately. The CNC does not keep the
part zero.
Automatic home search.
The home search is carried out on all the axes at the same
time, according to a subroutine pre-established by the
manufacturer. The CNC keeps the part zero.
Machine Z
The CNC shows the coordinates referred to part zero (O
P
)
considering the tool dimensions.
The CNC shows the coordinates referred to machine zero
(O
M
) considering the tool dimensions.
Press:
Press:
Machine X
Machine Ref.
Machine Ref.
Press:
To Next Page
Loading...
