Continuous jog. Feedrate in millimeters per minute.
While a jog key is kept pressed, the axes move at the
selected feedrate, considering the selected percentage (0%
to 120%).
• Enter the desired feedrate.
• Use the selector switch to select the type of feedrate and
the percentage to be applied.
• Jogging the axes with the jog keyboard.
• If the rapid key is pressed while jogging the axes, they will
move at the maximum feedrate possible (set by the
manufacturer).
+ Feedrate. +
"Rapid" key.
Incremental jog.
Every time a jog key is pressed, the axes move the selected
increment and at the programmed feedrate (in rapid if F=0).
• Use the selector switch to select the type of feed.
(1) Movement: 0.001 mm.
(10) Movement: 0.010 mm.
(100) Movement: 0.100 mm.
(1000) Movement: 1.000 mm.
(10000) Movement: 10.000 mm.
• Jogging the axes with the jog keyboard.
If the feedrate is defined in millimeters per
turn, there must be a speed selected at
the spindle.
To Next Page
Loading...
