Continuous jog. Feedrate in millimeters per turn.
In this mode, the feedrate depends on the status of the
spindle (stopped or turning).
• Enter the desired feedrate.
• Use the selector switch to select the type of feedrate and
the percentage to be applied.
• Jogging the axes with the jog keyboard.
• If the rapid key is pressed while jogging the axes, they will
move at the maximum feedrate possible (set by the
manufacturer).
+ Feedrate. +
"Rapid" key.
• Spindle status.
If the spindle is turning, the CNC moves the axes at the
selected feedrate.
If the spindle is stopped, but at the selected turning speed
S, the CNC calculates the theoretical feedrate (in mm/
min) and moves the axes at that feedrate.
If the spindle is stopped and no spindle speed S has been
selected, the axes will not move.
• If the rapid key is pressed while jogging the axes, they will
move at the maximum feedrate possible (set by the
manufacturer).
"Rapid" key.
To Next Page
Loading...
