Fagor CNC 8055 TC - Page 49

SELF-TEACHING MANUAL
49
·TC· Option
MANUAL PRACTICE.
3
• Calibrate the tool as follows.
1· Measure the part.
2· Start the spindle.
3· Select the tool to be calibrated. The CNC will assign the same offset number (D) to it.
4· Jog the axes until touching the part along the X axis.
Press [X]+[ENTER]. The CNC calculates and shows the new length. The offset value (I) is reset to 0.
Press [Z]+[ENTER]. The CNC calculates and shows the new length. The offset value (K) is reset to 0.
5· Enter the rest of the data (angle, width, radius and location code) by hand.
To calibrate another tool, repeat steps 3, 4 and 5.
+(Tool number) +
• Go to the window for tool calibration.
• Enter the X value.
• Enter the Z value.
Part dimensions.