Fagor CNC 8055 TC - Page 60

Self-teaching manual
60
·TC· Option
OPERATIONS OR CYCLES.
4
DEFINING THE DATA OF THE OPERATION OR CYCLE.
To select an icon, data or coordinate:
After this selection:
Move the cursor through the data or icons.
The CNC selects the first coordinate for that axis. Pressing it again selects the second coordinate.
The CNC selects the roughing feedrate. Pressing it again selects the finishing feedrate.
The CNC selects the roughing tool. Pressing it again selects the finishing tool.
The CNC selects the roughing speed. Pressing it again selects the finishing speed.
If it is a data, key in the new value and press [ENTER].
If it is an icon, press the two-color key until choosing the right one and press [ENTER].
If it is a coordinate, there are two choices:
• Key in the new value and press [ENTER].
• Assign the current cursor position to the data. Press [RECALL]+[ENTER].
+