Fagor CNC 8055 TC - Page 64

Self-teaching manual
64
·TC· Option
OPERATIONS OR CYCLES.
4
GRAPHIC OPTIONS. TYPE OF GRAPHIC.
• "3D" graphics.
It uses color lines to draw the tool path. When selecting this type of graphics, the screen only shows half of the part. This
is because it only shows the path of the tool tip (not the part itself).
• "Solid" graphics.
It starts with an initial block (raw stock). The simulation shows how the tool removes material. It shows the resulting shape
of the part.
Graphic representation.
To later check the part dimensions later on the simulation
screen, it must be done with a tool whose tip (nose) radius R=0.