SELF-TEACHING MANUAL
67
·TC· Option
OPERATIONS OR CYCLES.
4
4.3.3 Executing an operation or cycle.
Once all the data has been defined, press [ESC]. The CNC screen shows the "cycle start" symbol indicating that the operation
may be executed.
Once the execution has started:
The execution may be interrupted any time, except during the threading operation. In this case, the execution will stop at the
end of the threading operation.
This key may be used to choose whether the operations may be executed from beginning to end or one pass at a time.
It starts the execution of the operation or cycle.
Interrupt the execution.
If the execution is interrupted, it resumes it.
If the execution is interrupted, it cancels it definitely.
It goes into graphics mode.
To Next Page
Loading...
