Self-teaching manual
68
·TC· Option
OPERATIONS OR CYCLES.
4
TOOL INSPECTION.
With this option, it is possible to interrupt the execution of an operation to inspect the tool, change its wear, replace it, etc.
• Interrupt the execution.
• Depending on the manufacturer, accessing tool inspection on some machines may require pressing also the [T] key.
• The top of the CNC screen shows the message "INSPECTION". Within the "tool inspection" mode, it is possible
to move the axes (jog or handwheels), check the tool, change the tool, stop and start the spindle, change the tool
wear, etc.
• Repositioning the axes. If more than one axis has been moved, the CNC will request the repositioning command.
• Resuming execution.
To Next Page
Loading...
