SELF-TEACHING MANUAL
69
·TC· Option
OPERATIONS OR CYCLES.
4
MODIFYING TOOL WEAR.
This option may be used to change the I, K values. The values entered are incremental and are added to the ones stored earlier.
This option may be executed during tool inspection or while the machine is running.
NOTE: The changes are not assumed until the tool is selected.
• The CNC goes into tool calibration and shows the data for that tool.
• Select the I data with the cursor.
• Key in the I value and press [ENTER].
• Select the K data with the cursor.
• Key in the K value and press [ENTER].
• To change the offset of another tool, select it.
• Press [ESC] to end it.
To Next Page
Loading...
