Fagor CNC 8055 TC - 6.3 Modifying a Part-Program

SELF-TEACHING MANUAL
95
·TC· Option
CONVERSATIONAL PART PROGRAMS.
6
6.3 Modifying a part-program.
Select an operation and press [RECALL].
PART - PROGRAMS CYCLES
1 - TAPER TURNING CYCLE 1
2 - ROUNDING CYCLE 1
3 - TURNING CYCLE
- - CREATING A NEW PART - -
111 - THREADED AXIS
122 - TAPER AXIS
333 -
444 -
555 - EXAMPLE
The CNC shows the operation
with all the data. Modify the
parameters like in editing mode.
After modifying the data, press
[P.PROG].
PART - PROGRAMS CYCLES
1 - TAPER TURNING CYCLE 1
2 - ROUNDING CYCLE 1
3 - TURNING CYCLE
- - CREATING A NEW PART - -
111 - THREADED AXIS
122 - TAPER AXIS
333 -
444 -
555 - EXAMPLE
The CNC will request an option.
Select the "REPLACE" option
and press [ENTER].
The new operation replaces the
previous one.
Replacing an operation.