CNC 8055
CNC 8055i
SOFT: V02.2X
4
·111·
REMOTE MODULES (BUS CAN WITH
CANOPEN PROTOCOL)
Remote modules may be used to have an additional number of digital and analog inputs and outputs
(remote I/O) as well as inputs for temperature sensors. The remote modules are distributed by
groups and are connected to the central unit through the CAN bus.
Up to 4 groups may be connected to the CAN bus, where each group may consist of 1 or 2 of the
following elements.
A. Power supply with 24 digital inputs and 16 digital outputs.
This module must be powered at 24 V DC and connected to the system CAN bus.
B. Power supply with 4 analog inputs, 4 analog outputs and 2 inputs for temperature sensors.
This module must be powered at 24 V DC and connected to the system CAN bus.
C. Digital Inputs / Outputs (single module).
Each module has 24 digital inputs and 16 digital outputs.
D. Digital Inputs / Outputs (double module).
Each module has 48 digital inputs and 32 digital outputs.
Consumption
The consumption of each group is 1.2 A not including the consumption of the outputs.
POWER 24I/16O
X1
CHS
GN D
24V
SPEED
1
0
ADDRESS
ERR
RUN
CAN
0
1
LT
GN D
L
SH
H
SH
GN D
L
SH
H
SH
X2
X3
X7
I24
I13
X6
I12
I1
X5
GN D
O16
O9
+24V
O1
+24V
X4
GN D
O8
POWER
ANALOG I/O
X1
CHS
GN D
24V
SPEED
1
0
ADDRESS
ERR
RUN
CAN
0
1
LT
GN D
L
SH
H
SH
GN D
L
SH
H
SH
X2
X3
01
01
SH
X4
RL1
R1
R1
RF1
SH
X5
12
I1
I1
SH
12
GN D
X6
DIGITAL IN/OUT
X8
I24
I13
X7
I12
I1
X6
GN D
O16
O9
+24V
O1
+24V
X5
GN D
O8
X4
I24
I13
X3
I12
I1
X2
GN D
O16
O9
+24V
O1
+24V
X1
GN D
O8
DIGITAL IN/OUT
X4
I24
I13
X3
I12
I1
X2
GN D
O16
O9
+24V
O1
+24V
X1
GN D
O8
To Next Page
Loading...
