Fagor CNC 8055i FL EN - Power Supply

·114·
Installation manual
CNC 8055
CNC 8055i
4.
REMOTE MODULES (BUS CAN WITH CANOPEN PROTOCOL)
SOFT: V02.2X
Power supply
4.2 Power supply
The power supply must be powered at 24 V DC and connected to the CAN bus of the system.
There are two power supply models.
• Power supply with 24 digital inputs and 16 digital outputs.
• Power supply with 4 analog inputs, 4 analog outputs and 2 inputs for temperature sensors.
POWER 24I/16O
X1
CHS
GN D
24V
SPEED
1
0
ADDRESS
ERR
RUN
CAN
0
1
LT
GN D
L
SH
H
SH
GN D
L
SH
H
SH
X2
X3
X7
I24
I13
X6
I12
I1
X5
GN D
O16
O9
+24V
O1
+24V
X4
GN D
O8
Connector ·X6·.
12 digital inputs.
Connector ·X4·.
8 digital outputs.
Connector ·X1·.
Power supply.
Connector ·X2·.
CAN bus connection.
·SPEED· selector.
CAN bus transmission speed.
·Line Term· selector.
Line terminating resistor.
·ADDRESS· selector.
Address (node) of the element within the CAN
bus.
·X3· connector.
CAN bus connection.
Leds.
Status indicators.
Power supply with digital
inputs and digital outputs.
Connector ·X5·.
8 digital outputs.
Connector ·X7·.
12 digital inputs.