Installation manual
CNC 8055
CNC 8055i
REMOTE MODULES (BUS CAN WITH CANOPEN PROTOCOL)
4.
SOFT: V02.2X
·121·
Digital inputs and digital outputs (single module)
Description of the connectors (digital inputs and outputs)
Connector ·X1· & ·X2·. Digital outputs (8 outputs in each connector).
10-pin male Phoenix minicombicon connector (3.5 mm pitch).
Both connectors must be powered with 24 V DC and GND.
Connector ·X3· & ·X4·. Digital inputs (12 inputs in each connector).
12-pin male Phoenix minicombicon connector (3.5 mm pitch).
Signal Function
+ 24 V Power supply.
O1 - O8 Digital outputs.
O9 - O16 Digital outputs.
11 Power supply.
Signal Function
I1 - I12 Digital inputs.
I13 - I24 Digital inputs.
X1
O1
+24V
GN D
O8
O2
O3
O4
O5
O6
O7
X2
O9
+24V
GN D
O16
O10
O11
O12
O13
O14
O15
I12
I1
I24
I13
X3 X4
I2
I3
I4
I5
I6
I7
I8
I9
I10
I11 I23
I22
I21
I20
I19
I18
I17
I16
I15
I14
To Next Page
Loading...
