Installation manual
CNC 8055
CNC 8055i
REMOTE MODULES (BUS CAN WITH CANOPEN PROTOCOL)
4.
SOFT: V02.2X
·123·
Digital inputs and digital outputs (double module)
Description of the connectors (digital inputs and outputs)
Connector ·X1· & ·X2· & ·X5· & ·X6·. Digital outputs (8 outputs in each connector).
10-pin male Phoenix minicombicon connector (3.5 mm pitch).
Both connectors must be powered with 24 V DC and GND.
Connector ·X3· & ·X4· & ·X7· & ·X8·. Digital inputs (12 inputs in each connector).
12-pin male Phoenix minicombicon connector (3.5 mm pitch).
Signal Function
+ 24 V Power supply.
O1 - O8 Digital outputs.
O9 - O16 Digital outputs.
11 Power supply.
Signal Function
I1 - I12 Digital inputs.
I13 - I24 Digital inputs.
X1-X5
O1
+24V
GN D
O8
O2
O3
O4
O5
O6
O7
X2-X6
O9
+24V
GN D
O16
O10
O11
O12
O13
O14
O15
I12
I1
I24
I13
X3-X7 X4-X8
I2
I3
I4
I5
I6
I7
I8
I9
I10
I11 I23
I22
I21
I20
I19
I18
I17
I16
I15
I14
To Next Page
Loading...
