·126·
Installation manual
CNC 8055
CNC 8055i
4.
REMOTE MODULES (BUS CAN WITH CANOPEN PROTOCOL)
SOFT: V02.2X
Numbering of the digital inputs and outputs
4.6 Numbering of the digital inputs and outputs
The following PLC machine parameters identify each of the 4 possible remote modules. The
following group of parameters must be defined for each one of them.
IOCANID* Node address.
ICAN* Number of digital inputs of the group.
OCAN* Number of digital outputs of the group.
NUICAN* Number of the first digital input of the group.
NUOCAN* Number of the first digital output of the group.
IANALOG* Number of analog inputs of the group.
OANALOG* Number of analog outputs of the group.
PT100_* Number of physical connections for PT100 probes of the group.
NUIANA* Number of the first analog input of the group.
NUOANA* Number of the first analog output of the group.
Refer to the parameters and examples of how to set the remote modules. See "6.9 PLC Parameters"
on page 277.
To Next Page
Loading...
