Installation manual
CNC 8055
CNC 8055i
MACHINE PARAMETERS
6.
SOFT: V02.2X
·143·
FBALTIME (P12)
This parameter indicates the maximum time that the axis may stay without properly responding to
the CNC’s command. Axis parameter FBALTIME (P12) must be set with a proper value (other than
0).
MAXFLWE1 (P21)
This parameter indicates the maximum following error allowed when this axis moves. The value of
axis parameter MAXFLWE1 (P21) must be slightly higher than the amount of following error (lag)
in G0.
MAXFLWE2 (P22)
This parameter indicates the maximum following error allowed when this axis is stopped. The value
of MAXFLWE2 (P22) must be snug, i.e. the value must not be too large.
MAXCOUPE (P45)
This parameter indicates the maximum difference allowed between the following errors of the Gantry
axes that electronically coupled. Axis parameter MAXCOUPE (P45) must be set with a proper value
(other than 0). Only for Gantry or slaved axes.
FLIMIT (P75)
This parameter indicates the maximum safety limit the axis feedrate. Axis parameter FLIMIT (P75)
must be set with a proper value (other than 0).
ADIFEED (P84)
This parameter sets indicates the maximum feedrate allowed due to the additive handwheel. Axis
parameter ADIFEED (P84) must be set with a proper value (other than 0).
FRAPIDEN (P85)
This parameter indicates the maximum axis feedrate when activating the EXRAPID mark and when
pressing the rapid key in execution or in simulation with motion. Axis parameter FRAPIDEN (P85)
must be set with a proper value (other than 0).
Spindle parameters
FBACKAL (P15)
This parameter indicates whether the feedback alarm for the spindle will be ON or OFF. Spindle
parameter FBACKAL (P15) must be set to ON.
MAXFLWE1 (P21)
This parameter indicates the maximum following error allowed for the spindle when moving in closed
loop (M19). The value of spindle parameter MAXFLWE1 (P21) must be slightly higher than the
amount of following error (lag) in G0.
MAXFLWE2 (P22)
This parameter indicates the maximum following error allowed for the spindle when stopped in
closed loop (M19). The value of MAXFLWE2 (P22) must be snug, i.e. the value must not be too large.
SYNPOSOF (P53)
This parameter indicates the maximum shift (offset) between the main spindle and the second one
when they are synchronized in position. Spindle parameter SYNPOSOF (P53) must be set with a
proper value (other than 0).
SYNSPEOF (P54)
This parameter indicates the maximum speed error (offset) between the main spindle and the
second one when they are synchronized in speed. Spindle parameter SYNSPEOF (P54) must be
set with a proper value (other than 0).
To Next Page
Loading...
