·144·
Installation manual
CNC 8055
CNC 8055i
6.
MACHINE PARAMETERS
SOFT: V02.2X
SYNMAXSP (P63)
This parameter indicates the maximum turning speed when the spindle are synchronized. Spindle
parameter SYNMAXSP (P63) must be set with a proper value (other than 0).
SLIMIT (P66)
This parameter sets the maximum safety limit for the spindle speed. Spindle parameter SLIMIT
(P66) must be set with a proper value (other than 0).
PLC Parameters.
WDGPRG (P0)
This parameter sets the Watchdog time-out period for the main PLC program. PLC parameter
WDGPRG (P0) must be set with a proper value.
WDGPER (P1)
This parameter sets the Watch-Dog time-out period for the periodic module of the PLC. Only if a
periodic subroutine has been defined. PLC parameter WDGPER (P1) must be set with a proper
value.
To Next Page
Loading...
