·242·
Installation manual
CNC 8055
CNC 8055i
6.
MACHINE PARAMETERS
SOFT: V02.2X
Spindle parameters
6.5 Spindle parameters
This CNC can control the main spindle, a second spindle and an auxiliary spindle They all have their
own setup parameters. The main and secondary spindle have identical parameter tables.
In order to synchronize the main and secondary spindles, they both must have a feedback device,
their spindle parameter M19TYPE (P43) must be set to "1" and their parameters defining the third
set of gains and accelerations must be set for a similar behavior of both spindles.
The G77 function synchronizes the spindles in speed, so the secondary spindle turns at the same
speed as the main spindle.
The G30 function synchronizes the spindles in position and it sets an angular offset between them
so the secondary spindle follows the main spindle maintaining that offset.
To Next Page
Loading...
