·264·
Installation manual
CNC 8055
CNC 8055i
6.
MACHINE PARAMETERS
SOFT: V02.2X
Spindle parameters
MAXVOLT (P4)
Indicates the velocity command corresponding to the maximum speed defined by spindle parameter
MAXSPEED (P0).
DRIBUSID (P5)
It indicates the address of the digital drive (Sercos or CAN) associated with the auxiliary spindle.
It corresponds with the value of the drive's rotary switch (address, device select).
It is recommended (not necessary) that the Can addresses of the various axes and spindles be
consecutive and start from number ·1· (the address of the CNC is always ·0·). For example, with
3 Sercos axes and 1 Sercos spindle, the values of this parameter must be 1, 2, 3 and 4. Proceed
in the same way if it is a CAN connection.
Possible values
Integer numbers between 0 mV and 9999 mV.
Default value: 9500 (9.5 V)
Value Meaning
0 Analog axis.
1 - 8 Address of the digital drive.
Default value: 0
To Next Page
Loading...
