·266·
Installation manual
CNC 8055
CNC 8055i
6.
MACHINE PARAMETERS
SOFT: V02.2X
Drive parameters
• The ACCESS window shows the permitted access level. There are 3 levels of access for the
drive: basic level, OEM level (manufacturer) and Fagor level. To change the level, press the
[Password] softkey, key in the relevant code and press [ENTER].
• The VERSION window shows the software version installed at the drive, the name of the motor
associated with the drive and the drive model.
Softkeys available in this mode
Password
Modifies the access level selected in the "Access" window.
In the case of CAN servo system, to access the drive parameters with an OEM access level, the
password is defined in Utilities mode as OEMPSW; not a pre-established one as when using Sercos .
Modify
To modify the variables that are not protected (those without a key icon).
After selecting the variable with the [] [] keys, pressing the "modify" softkey displays two windows.
The first one shows the range of possible values and the second one the current value. Enter the
new value and press [ENTER].
The drive assumes that value and refreshes the screen.
Execute command
Shows the list of commands that can be executed by the drive. Select one using the [] [ keys
and press [ENTER].
Change group
Selects the group of parameters or variables to be displayed.
Change set
Selects the set number of the parameters or variables to be displayed.
To drive flash
The drive stores all its parameters in its flash memory and it then executes a soft-reset command.
This command interrupts the communication, press [ENTER] to restore it.
Save
It makes a copy of the parameters of the drive's RAM memory into the CNC's hard disk (KeyCF)
or to a peripheral device or PC through the serial line.
The parameters are storedwith the name of the axis they are associated with (for example, the X
axis parameters). A file saved from the CNC via WinDNC may be loaded into the drive via
DDSSETUP and vice versa.
Load
It copies into the drive's RAM memory the parameters saved in the CNC's hard disk (KeyCF) or in
a peripheral device or in PC through the serial line.
The CNC copies the axis parameters that are being edited.
Drive Errors
It displays a window with the warnings and errors of the drive. If all of them do not fit on the screen,
use [] [].
Options
It shows a screen where one can select to display either all the parameters and variables or just
the ones than can be modified.
To Next Page
Loading...
