·274·
Installation manual
CNC 8055
CNC 8055i
6.
MACHINE PARAMETERS
SOFT: V02.2X
Ethernet parameters
IPSNFS (P28)
IP address of the server acting as remote hard disk.
If other than 0, the remote hard disk is activated. This means that the local hard disk, if there is any,
is disabled and can no longer be accessed.
DIRNFS (P29)
Directory of the server that is used as remote hard disk.
MACID (P30)
Reserved. It must be set to "0".
ETHEINLE (P31)
Not used.
NFSPROTO (P32)
Using this Ethernet parameter, it is possible to select the desired protocol when configuring a remote
hard disk using NFS.
The TCP protocol is more safer but in some network configurations copying and refreshing folders
with lots of programs becomes very slow as compared to the UDP protocol.
The parameter NFSPROTO (P32) is validated with SHIFT/RESET or on power-up.
CNC connection in an Ethernet network.
Connection using Windows
®
95 or 98
Connection with a shared CNC without password
At the Web browser (e.g. IExplorer) or from the file explorer (only on Windows 98), write in the
command line the CNC's IP address.
For example: ftp://10.0.7.224
Connection with a shared CNC with password
At the Web browser (e.g. IExplorer) or from the file explorer (only on Windows 98), write in the
command line the user name, the password and the CNC's IP address. The user name is always
"cnc".
For example: ftp://cnc:password@10.0.17.62
Assign a name to the IP address
The IP address may be assigned a name for easier identification. This operation is carried out at
the PC and there are two different ways to do it.
Possible values
Four numbers between 0 and 255 separated by dots.
Default value: 0.0.0.0 (there is no remote hard disk)
Possible values
It admits up to a maximum of 22 characters (without blank spaces).
Default value: Nameless
Value Meaning
0 The TCP protocol will be used.
1 The UDP protocol will be used.
Default value: 0
To Next Page
Loading...
