·286·
Installation manual
CNC 8055
CNC 8055i
6.
MACHINE PARAMETERS
SOFT: V02.2X
Tables
bit 2
Indicates whether the M function interrupts the block preparation or not.
bit 3
Indicates whether the M function is executed or not after the associated subroutine is executed.
bit 4
When bit "2" has been set to "1", it indicates whether block preparation is to be interrupted until the
execution of the M function begins or until it ends (until the M-done signal is received).
bit 5
Not being used at this time.
bit 6
Not being used at this time.
bit 7
Not being used at this time.
When executing an M function which has not been defined in the M table, the programmed function
will be executed at the beginning of the block and the CNC will "wait" for the "AUXEND" signal to
continue the execution of the program.
Value Meaning
0 It does NOT interrupt the block preparation.
1 It interrupts the block preparation.
Value Meaning
0 It is executed after the associated subroutine.
1 ONLY the associated subroutine is executed.
Value Meaning
0 It interrupts block preparation until the execution of the "M" function begins.
1 It interrupts block preparation until the "M-done" signal (AUXEND) is received.
To Next Page
Loading...
