·288·
Installation manual
CNC 8055
CNC 8055i
6.
MACHINE PARAMETERS
SOFT: V02.2X
Tables
Considerations and limitations.
When defining the profile points in the table, the following requirements must be met:
• The axis points must be in sequential order starting from the most negative (least positive) point
to be compensated.
• For those points outside the compensation zone, the CNC will apply the compensation value
corresponding to the table point closest to them.
• The amount of error of the machine reference point may have any value.
• The error difference between two consecutive points must not be greater than the distance
between them (maximum slope= 100%).
To Next Page
Loading...
