Installation manual
CNC 8055
CNC 8055i
CONCEPTS
7.
SOFT: V02.2X
·329·
Axis setting
Set axis parameters LSCRWCOM (P15) = ON and NPOINTS (P16) = 7
Considering that the Machine Reference Point (physical location of the marker pulse) is located 30
mm from HOME (machine reference zero), at X30. The leadscrew error compensation parameters
must be set as follows:
Point Position Positive error Negative error
P001 X -20.000 EX 0.001 EX 0
P002 X 0.000 EX -0.001 EX 0
P003 X 30.000 EX 0.000 EX 0
P004 X 60.000 EX 0.002 EX 0
P005 X 90.000 EX 0.001 EX 0
P006 X 130.000 EX -0.002 EX 0
P007 X 160.000 EX -0.003 EX 0
To Next Page
Loading...
