·340·
Installation manual
CNC 8055
CNC 8055i
7.
CONCEPTS
SOFT: V02.2X
Reference systems
7.6.4 Axis travel limits (software limits)
Once all the axes have been referenced, their software limits must be measured and set.
This operation must be carried out one axis at a time and it could be done as follows:
• Move the axis in the positive direction towards the end of the axis travel stopping at a safe
distance from the mechanical end-of-travel stop.
• Assign the coordinate shown by the CNC for that point to axis parameter LIMIT+ (P5).
• Repeat these steps in the negative direction assigning the resulting coordinate to axis parameter
LIMIT- (P6).
• Once both travel limits have been set for all the axes, press SHIFT + RESET or turn the CNC
OFF and back ON in order for these new values to be assumed by the CNC.
To Next Page
Loading...
