Installation manual
CNC 8055
CNC 8055i
CONCEPTS
7.
SOFT: V02.2X
·347·
Main and second spindle
Work plane selection
Use function G16 to select the work plane. See programming manual.
Machining canned cycles
When working in a plane other than the ZX, for example: G16 WX, the CNC interprets the canned
cycle parameters as follows:
• Parameter Z and all those related to it, with the abscissa axis (W in the example).
• Parameter X and all those related to it, with the ordinate axis (X in the example).
Tool compensation
When working in a plane other than ZX, for example G16 WX, the CNC allows associating the tool
offset table to the work plane.
To do that, set general parameter PLACOMP (P78) to "1". See "6.3 General machine parameters"
on page 148.
When general parameter PLACOM = 1, the CNC interprets the tool table as follows:
ZX plane WX plane
The Z and K parameters, with the abscissa axis Z axis W axis
The X and I parameters, with the ordinate axis X axis X axis
To Next Page
Loading...
