Fagor CNC 8055i FL EN - Page 35

Installation manual
CNC 8055
CNC 8055i
8055 CNC CONFIGURATION
1.
SOFT: V02.2X
·35·
Central unit
Recommended RS232C interface connection.
Slot "KEYCF" - Compartment of the KeyCF (CNC configuration card)
It has a compact flash type hard disk to store user programs and for updating software versions.
The hard disk may be accessed from the outside.
The KeyCF supplied by Fagor with each CNC has an identification code corresponding to:
• The card id (all the cards are different).
• The software features that have been purchased for that unit
The id code only needs very little memory space. The rest of memory space of the KeyCF may be
used to store data on machine customizing (user screens, PLC program backup and/or machine
parameters, etc.) as well as user part-programs.
The CNC will recognize the KeyCF as <Hard Disk>.
When having the Ethernet option, it is possible to use a PC directory as a remote hard disk.
Simplified connection Full connection.
CNC PC (9pin)
Hold Hold
FG
RxD
TxD
DSR
DTR
CTS
RTS
GND
DCD
RxD
TxD
DTR
DSR
RTS
CTS
GND
1
2
3
4
6
7
8
5
1
2
3
6
4
8
7
5
CNC PC (25pin)
Hold
Hold
FG
TxD
RxD
DSR
DTR
CTS
RTS
GND
DCD
RxD
TxD
DTR
DSR
RTS
CTS
GND
1
2
3
4
6
7
8
5
1
2
3
6
20
5
4
7
CNC PC (9pin)
Hold Hold
FG
RxD
TxD
DSR
DTR
CTS
RTS
GND
DCD
RxD
TxD
DTR
DSR
RTS
CTS
GND
1
2
3
4
6
7
8
5
1
2
3
6
4
8
7
5
CNC PC (25pin)
Hold Hold
FG
TxD
RxD
DSR
DTR
CTS
RTS
GND
DCD
RxD
TxD
DTR
DSR
RTS
CTS
GND
1
2
3
4
6
7
8
5
1
2
3
6
20
5
4
7