Installation manual
CNC 8055
CNC 8055i
CONCEPTS
7.
SOFT: V02.2X
·373·
Axes (2) controlled by a single drive
DRIBUSLE=2
Sercos connection with DRIBUSLE=2. The axis feedback is handled via Sercos, second feedback
(direct feedback) and the command for the drive is sent via Sercos.
Notes
When selecting the number of encoder pulses, bear in mind the maximum spindle rpm so they do
not exceed the maximum feedback reading frequency.
When working with Sercos, the motor-drive system is supposed to know the spindle-C-axis position
at all times, even after turning it off and back on. If it is an analog system, after turning the CNC on,
it performs a home search automatically before moving the spindle or the C axis for the first time.
Spindle (S) "C" axis
DRIBUSLE (P51) = 2 DRIBUSLE
SWITCHAX
SWINBACK
(P63) = 2
(P65) = 10
(P66) = 0
To Next Page
Loading...
