Fagor CNC 8055i FL EN - Page 403

Installation manual
CNC 8055
CNC 8055i
CONCEPTS
7.
SOFT: V02.2X
·403·
Gear ratio management on axes and spindle
2. External encoder connected to the CNC
 spindle parameter DRIBUSLE (P51) = 0.
Parameters involved in the calculation of the velocity command:
 spindle parameter MAXGEAR1 (P2) = maximum rpm of the first gear = 1000.
 spindle parameter MAXGEAR2 (P3) = maximum rpm of the second gear = 2000.
 spindle parameter MAXGEAR3 (P4) = maximum rpm of the third gear = 3000.
 spindle parameter MAXGEAR4 (P5) = maximum rpm of the fourth gear = 3500.
 spindle parameter INPREV1 (P72) = Input revolutions of the first gear =4.
 spindle parameter INPREV2 (P74) = Input revolutions of the second gear =2.
 spindle parameter INPREV3 (P76) = Input revolutions of the third gear =4.
 spindle parameter INPREV4 (P78) = Input revolutions of the fourth gear =1.
 spindle parameter OUTPREV1 (P73) = output revolutions of the first gear =1.
 spindle parameter OUTPREV2 (P75) = output revolutions of the second gear =1.
 spindle parameter OUTPREV3 (P77) = output revolutions of the third gear =3.
 spindle parameter OUTPREV4 (P79) = output revolutions of the fourth gear =1.
Parameters involved in the calculation of the position feedback.
 axis parameter NPULSES (P13) = number of pulses per turn of the encoder = 18000.
 axis parameter SINMAGNI (P65) = Multiplying factor if the encoder is sinusoidal = 200.
CAN spindle
1. External encoder connected to the CNC
 spindle parameter DRIBUSLE (P51) = 0.
Parameters involved in the calculation of the velocity command:
 spindle parameter MAXGEAR1 (P2) = maximum rpm of the first gear = 1000.
 spindle parameter MAXGEAR2 (P3) = maximum rpm of the second gear = 2000.
 spindle parameter MAXGEAR3 (P4) = maximum rpm of the third gear = 3000.
 spindle parameter MAXGEAR4 (P5) = maximum rpm of the fourth gear = 3500.
 spindle parameter INPREV1 (P72) = Input revolutions of the first gear =4.
 spindle parameter INPREV2 (P74) = Input revolutions of the second gear =2.
 spindle parameter INPREV3 (P76) = Input revolutions of the third gear =4.
 spindle parameter INPREV4 (P78) = Input revolutions of the fourth gear =1.
 spindle parameter OUTPREV1 (P73) = output revolutions of the first gear =1.
 spindle parameter OUTPREV2 (P75) = output revolutions of the second gear =1.
 spindle parameter OUTPREV3 (P77) = output revolutions of the third gear =3.
 spindle parameter OUTPREV4 (P79) = output revolutions of the fourth gear =1.
Parameters involved in the calculation of the position feedback.
 axis parameter NPULSES (P13) = number of pulses per turn of the encoder = 18000.
 axis parameter SINMAGNI (P65) = Multiplying factor if the encoder is sinusoidal = 200.