·496·
Installation manual
CNC 8055
CNC 8055i
12.
LOGIC CNC INPUTS AND OUTPUTS
SOFT: V02.2X
General logic inputs
SKIPCYCL (M5064)
During the drilling, tapping and rigid tapping cycles of the mill model CNC, it is now possible to
withdraw the tool to the starting plane and, once there, stop the spindle.
Once the retraction is completed, the user may finish the hole, go to the next hole or go into tool
inspection.
General logic input SKIPCYCL (M5064) is used to go to the next hole, once the withdrawal is
completed.
RETRACYC (M5065)
During the drilling, tapping and rigid tapping cycles of the mill model CNC, it is now possible to
withdraw the tool to the starting plane and, once there, stop the spindle.
Once the retraction is completed, the user may finish the hole, go to the next hole or go into tool
inspection.
The PLC activates this mark and the CNC cancels it automatically once the Z axis stopped and
before beginning to retract.
SETTMEM (M5066)
PLC mark used by the OEM to activate an error message during tool change. When this mark is
activated, the CNC activates the TMINEM mark.
RESTMEM (5067)
PLC mark that may be used to cancel the error state of the CNC. This mark is activated when the
user confirms that the tool magazine has been inspected and that everything is OK to continue
working.
To Next Page
Loading...
