Installation manual
CNC 8055
CNC 8055i
LOGIC CNC INPUTS AND OUTPUTS
12.
SOFT: V02.2X
·517·
General logic outputs
DM04 (M5543)
The CNC sets this signal high to tell the PLC that the spindle is turning counter-clockwise or that
the auxiliary function M04 is programmed in the block being executed.
DM05 (M5542)
The CNC sets this signal high to tell the PLC that the spindle is stopped or that the auxiliary function
M05 is programmed in the block being executed.
DM06 (M5541)
The CNC sets this signal high to tell the PLC that the spindle is stopped or that the auxiliary function
M06 is programmed in the block being executed (tool change).
DM08 (M5540)
The CNC sets this signal high to tell the PLC that the coolant output is activated or that the auxiliary
function M08 is programmed in the block being executed.
DM09 (M5555)
The CNC sets this signal high to tell the PLC that the coolant output is deactivated or that the auxiliary
function M09 is programmed in the block being executed.
DM19 (M5554)
The CNC sets this signal high to tell the PLC that it is working with spindle orientation or that the
auxiliary function M19 is programmed in the block being executed.
DM30 (M5553)
The CNC sets this signal high to tell the PLC that the auxiliary function M30 (program end) is
programmed in the block being executed.
DM41 (M5552)
The CNC sets this signal high to tell the PLC that the first spindle gear is selected or that the auxiliary
function M41 is programmed in the block being executed.
DM42 (M5551)
The CNC sets this signal high to tell the PLC that the second spindle gear is selected or that the
auxiliary function M42 is programmed in the block being executed.
DM43 (M5550)
The CNC sets this signal high to tell the PLC that the third spindle gear is selected or that the auxiliary
function M43 is programmed in the block being executed.
DM44 (M5549)
The CNC sets this signal high to tell the PLC that the fourth spindle gear is selected or that the
auxiliary function M44 is programmed in the block being executed.
DM45 (M5548)
The CNC sets this signal high to tell the PLC that the miscellaneous function M45 has been
programmed and, therefore, the "auxiliary spindle or live tool" is active.
TANGACT (M5558)
It indicates that the tangential control function, G45, is active.
SYNCPOSI (M5559)
Indicates that the spindles are synchronized in position (set high). In other words, that the second
spindle follows behind the main spindle at an angular distance set by G30.
It goes low when the following error between them exceeds the maximum allowed by spindle
parameter "SYNPOSOF (P53)".
To Next Page
Loading...
