Installation manual
CNC 8055
CNC 8055i
LOGIC CNC INPUTS AND OUTPUTS
12.
SOFT: V02.2X
·519·
General logic outputs
WRITERDY (M5572)
CNC output that indicates whether the WRITE commands may be sent or not.
NT2STROBE (M5573)
Logic output used to manage the tool magazine, by providing the PLC with information on the tool
that is to be returned to the magazine. Indicates that there is new information in the PLC register
NT2BCD (R572).
This information will be sent out for any type of magazine with an automatic tool changer as long
as the bit 12 of general parameter TOOLTYPE (P167) is active.
Value Meaning
0 It indicates that no WRITE commands may be sent.
1 It indicates that WRITE commands may be sent.
To Next Page
Loading...
