Installation manual
CNC 8055
CNC 8055i
LOGIC CNC INPUTS AND OUTPUTS
12.
SOFT: V02.2X
·523·
Spindle logic outputs.
When working with M03 and M04 the CNC sets this signal high to tell the PLC that the real spindle
revolutions correspond to those programmed.
The CNC will activate this signal every time the real revolutions are within the range defined by
spindle parameters "LOSPDLIM" and "UPSPDLIM".
When working with the spindle in closed loop (M19), the CNC sets this signal high if the spindle is
stopped.
INPOSS (M5957) Main spindle
INPOSS2 (M5982) Second spindle
This signal is used when working with the spindle in closed loop (M19). The CNC only considers
the signals for the currently selected spindle.
The CNC sets this signal high to tell the PLC that the spindle is in position.
To Next Page
Loading...
