Installation manual
CNC 8055
CNC 8055i
ACCESS TO INTERNAL CNC VARIABLES
13.
SOFT: V02.2X
·529·
Variables associated with tools.
13.1 Variables associated with tools.
These variables are associated with the tool offset table, tool table and tool magazine table, so the
values which are assigned to or read from these fields will comply with the formats established for
these tables.
Tool table for mill model CNC.
The radius (R), length (L) and wear offset (I, K) values of the tool are given in the units set by general
parameter INCHES.
If, INCHES = 0, in ten-thousandths of a millimeter (±999999999).
If INCHES = 1, in hundred-thousandths of an inch (±393700787).
If rotary axis, in ten-thousandths of a degree (±999999999).
Tool table for lathe model CNC.
The length (X, Z), radius (R) and wear offset (I, K) values of the tool are given in the units set by
general parameter INCHES.
If, INCHES = 0, in ten-thousandths of a millimeter (±999999999).
If INCHES = 1, in hundred-thousandths of an inch (±393700787).
If rotary axis, in ten-thousandths of a degree (±999999999).
The location (tool shape) code (F) will be an integer between 0 and 9.
Tool table at the mill model CNC.
The tool offset number is an integer between 0 and 255. The maximum number of tool offsets is
limited by general parameter NTOFFSET.
The family code is a number between 0 and 255.
0 to 199 if it is a normal tool.
200 to 255 if it is a special tool.
The nominal life is given either in minutes or in operations (0··65535).
The real (actual) life is given either in hundredths of a minute (0··9999999) or in operations
(0··999999).
Tool table at the lathe model CNC.
The tool offset number is an integer between 0 and 255. The maximum number of tool offsets is
limited by general parameter NTOFFSET.
The family code is a number between 0 and 255.
0 to 199 if it is a normal tool.
200 to 255 if it is a special tool.
The nominal life is given either in minutes or in operations (0··65535).
The real (actual) life is given either in hundredths of a minute (0··9999999) or in operations
(0··999999).
The cutter angle is given in ten-thousandths of a degree (0··359999).
The cutter width is given in the units set by general parameter INCHES.
If, INCHES = 0, in ten-thousandths of a millimeter (±999999999).
If INCHES = 1, in hundred-thousandths of an inch (±393700787).
If rotary axis, in ten-thousandths of a degree (±999999999).
The cutting angle is given in ten-thousandths of a degree (0··359999).
To Next Page
Loading...
