Installation manual
CNC 8055
CNC 8055i
8055 CNC CONFIGURATION
1.
SOFT: V02.2X
·53·
Central unit
Connector X5 - TTL and differential TTL feedback signals
It is a 15-pin male connectors of the SUB-D type used for feedback system connection. It admits
differential (double-ended) and non-differential (single-ended) TTL feedback.
This connector may be connected to up to 2 axes. General parameters AXIS5 (P4) and AXIS6 (P5)
must be set to let the CNC know which axis has been connected to each one of them.
The cables must have overall shielding. The rest of the specifications depend on the feedback
system used and the cable length required.
The cable shield must be connected to the metallic hood at each end. The wires of the shielded cable
must not be longer than 75 mm without the protection shield.
It is highly recommended to run these cables as far as possible from the power cables of the machine.
Handwheel connection
When using a FAGOR 100P model handwheel, the axis selecting signal must be connected to the
reference mark (I0) pin of the corresponding axis 5 or 13 of this connector.
Protection at the connectors
It detects the error in axis pairs issuing the relevant error message.
"Supply voltage error on axis feedback *".
Pin Signal and function
1
2
3
4
A
/A
B
/B
Differential squarewave feedback signal.
5
6
I0
/I0
Home signals.
7
8
+5 V
0 V
Voltage supply for feedback systems.
9
10
11
12
A
/A
B
/B
Differential squarewave feedback signal.
13
14
I0
/I0
Home signals.
15 - - -
To Next Page
Loading...
