Installation manual
CNC 8055
CNC 8055i
8055 CNC CONFIGURATION
1.
SOFT: V02.2X
·55·
Central unit
Connector X9 - PLC inputs
It is a 37-pin male connector of the SUB-D type used for the PLC inputs.
Since the response time of the EMERGENCY signal must be very short, the CNC has assigned
input I1 (pin 2) for this purpose. Thus, the CNC will treat this input immediately regardless of how
the PLC program uses it.
The 0V of the power supply used for these inputs must be connected to pins 18 and 19 of the
connector.
All shields must only be connected to ground at the CNC end leaving the other end free. The wires
of the shielded cable must not be longer than 75 mm without the protection shield.
Pin Signal and function
1
2
3
4
5
- - -
I1
I3
I5
I7
/Emergency stop.
6
7
8
9
10
I9
I11
I13
I15
I17
11
12
13
14
15
I19
I21
I23
I25
I27
16
17
18
19
20
I29
I31
0 V
0 V
- - -
External power supply.
External power supply.
21
22
23
24
25
I2
I4
I6
I8
I10
26
27
28
29
30
I12
I14
I16
I18
I20
31
32
33
34
35
I22
I24
I26
I28
I30
36
37
I32
Chassis - Shield.
To Next Page
Loading...
