·554·
Installation manual
CNC 8055
CNC 8055i
13.
ACCESS TO INTERNAL CNC VARIABLES
SOFT: V02.2X
Variables associated with the live tool
13.12 Variables associated with the live tool
Read-only variables
ASPROG
It must be used inside the subroutine associated with function M45.
Returns the revolutions per minute programmed in M45 S. If programmed only in M45, the value
0 will be used.
The ASPROG variable is updated just before executing the M45 function so it is already updated
when executing its associated subroutine.
LIVRPM
It must be used when operating in TC mode.
It returns the rpm selected by the user for the live tool when in TC mode.
To Next Page
Loading...
